54
CM2115
Installation
10.1.2. Selecting a Mounting Location
The CM2115 can be installed in the vehicle's cab, engine compartment, or on the
chassis. If used for a marine application, ensure it is protected from excessive salt
spray.
Before mounting the CM2115, ensure you review the following environmental
and mechanical requirements.
Caution:
Do not install the CM2115 close to any significant heat
sources, such as a turbo, exhaust manifold, etc. Also avoid installing the
CM2115 near any drive-train component, such as a transmission or engine
block.
10.1.2.1. Mechanical Requirements
Review the following mechanical requirements before selecting a mounting
location for the CM2115:
The CM2115 should be mounted vertically so moisture will drain away from
it.
The wire harness should have drip loops incorporated into the design to divert
water away from the CM2115.
The harness should be shielded from harsh impact.
The harness should connect easily to the connector and have adequate bend
radius.
The labels should be easy to read.
The CM2115 should be in a location that is easily accessible for service.
10.1.2.2. Environmental Requirements
The CM2115 warranty does not cover damage caused by exposure of the
product to environmental conditions that exceed its design limitations.
