T6TR VHF 50 W Transceiver
Page 23
Installation
MARC Data Connector
The MARC Data connector is an 8-way RJ48 socket. It can be used as an alternative to the MARC
connector for data connections. The connector pin-out is shown below and detailed in Table 9.
Table 9 MARC Data Connector
Pin Number
Signal
Characteristic
1
2
Data in -
Data in +
RS422 differential asynchronous data, 9600 baud,
8 data bits, 1 stop bit, no parity, no handshaking.
3
Not connected
-
4
5
Data out +
Data out -
RS422 differential asynchronous data, 9600 baud,
8 data bits, 1 stop bit, no parity, no handshaking.
6
Remote Supply ON/OFF
(input)
0 V to switch off.
Note: Rear panel switch must be in ON position for
this function to operate.
7
Ground
0 V.
8
Unregulated supply
(output)
This output is between 21.6 and 32 Vdc (nominally
24 V) fused at 500 mA.
Pin 1
RJ48 Plug
Numbering is shown looking from the top of the connector.
The top is being viewed when the lever is on the bottom.
Summary of Contents for T6TR
