Patio Heater Instructions
OZGLOW HE 40 Hi/Lo
INSTALLATION INSTRUCTIONS - OPTION B
1.
Select a suitable location and fix the J
arm (or straight arm) to the roof structure
of the building or patio.
Method of bracketing frame into
position supplied by installer.
Ensure arm is straight and level.
2.
Feed 4 core electrical wire (supplied by
installer) down next to the gas pipe and
pull through far enough to enable joining
these wires to the wires on the heater
head.
3.
Trim the 4 wires on the heater head to
a
length of approximately 100 mm.
Enter the heater head into the top of the T
piece and rotate the head to tighten it onto
the hex nipple.
Use an approved thread sealant on these
joints. Make sure you finish with the
screw holes in the heater base lining up
with the holes in the T piece.
Use the 4 screws provided to fix the heater
head to the T piece.
© PARASOL HEATERS AUSTRALIA
+61 3 9549 4466 - Head 61 3 9546 6069
www.parasolheaters.com.au
Created on 24/09/2015
Page 13 of 18
