Start Up
Installation Steps
1. Make sure the water supply line is turned off at the
valve.
2. Remove plugs.
• Use the Removal Tool to remove the 1 1/2”
NPT Cap.
• Use a 3/8” socket extension to remove the
1/2” NPT Seal Plug (Fig. 1).
3. Turn on water supply line to flush line for a couple
of minutes. Then shut it off.
4. Install the 1 1/2” NPT Nut Retainer. Hand tighten
ONLY, even when using tool.
• Make sure that the Retainer Ring is installed
properly in the Retainer Nut. The retaining
piece with raised rounded center is inserted
facing the top of the retainer nut (Fig. 2).
• Use Removal Tool to install Nut Retainer.
Fig. 1
Seal Plug
1 1/2"
NPT Cap
Retaining Ring top view with
raised rounded center
Retaining Ring bottom view
with sharper center
Fig. 2
Top View: Correct
position of Retaining
Ring inside Retainer Nut
with rounded center
exposed.
Bottom View: Correct
position of Retaining
Ring inside Retainer
Nut with sharper center
exposed.
USE ONLY PARAMOUNT GENUINE REPLACEMENT PARTS
22