1. While holding the new float, twist sleeve
counter clockwise until it comes out of the
float.
2. Turn float over and re-thread on sleeve with
flat side up. Be careful not to cross-thread
(Fig. 12).
3. Compare the float height on the sleeve to the
old float. The new style float will need to be
approximately 5/8” lower on the sleeve to
achieve a similar water level (Fig. 13).
4. Install in the housing and turn on the water
supply.
5. If the float is off, shut off the water and re-
move the float and turn in the direction in-
dicated on the flat side of the float to raise
the water level 1/8”, one half turn, or 2
posi-clicks. Follow the arrows on the float
(Fig. 14).
6. If the float is on, shut off the water and re-
move the float and turn in the direction in-
dicated on the flat side of the float to raise
the water level 1/8”, one half turn, or two
(2) posi-clicks. Follow the arrows on the float
(Fig. 14).
7. Repeat steps 5a or 5b until water level is
matched.
8. Check pool level after a few days to verify
correct set level.
Use New Float in Old Tank
Fig. 12
Fig. 13
Fig. 14
Arrows
USE ONLY PARAMOUNT GENUINE REPLACEMENT PARTS
6