Copyright © Parallax Inc.
PING))) Kit for Stingray (#28985) 12/8/2009
Page 5 of 7
Using the same screws from step 2,
connect plate back on the Stingray.
Note: When connecting the plate, do not
tighten the screws until all 4 are in; this will
installing the sensors straight easier.
Step 7: Repeat (x2)
Connect the other two plates in the same
manner as the first.
Once completed, you should have no extra
screws and the robot should look similar to
this example.
Step 8: Connecting PING))) to I/O
With the Stingray oriented so that the
PING))) modules are facing away from you;
the numbering goes as followed:
Left PING))) to I/O pin 0
Center PING))) to I/O pin 1
Right PING))) to I/O pin 2
