Copyright © Parallax Inc.
PING))) Kit for Stingray (#28985) 12/8/2009
Page 2 of 7
Assembly Instructions
Step 1: Part Verification
Unpack everything from the packages and
make sure you have all the parts and that
you have the tools listed below.
1 – Built-up Stingray Robot
3 – PING))) Ultrasonic Range
Sensors
6 – 4/40 Zinc nuts
6 – 4/40 1/2” zinc pan head screws
6 – 3/16” #8 Plastic Spacers
3 – 10” Extension cable
6 – Nylon Washer #4
3 – Rubber Grommet
1 – Parallax screw driver *
1 – 1/16” Hex Key *
Note: Tools indicated with a * are provided
in the Stingray Robot Kit and not included in
the PING))) Kit.
Step 2: Disassemble
Using the 1/16” Hex key that came with the
Stingray Robot kit; start by unscrewing the
front sensor mount plates, hereafter referred
to as plates or plate.
Each plate will have 4 screws connecting to
the chassis, two on top and two on bottom.
Once removed, keep these screws in a
secure place.
Once all 3 plates are out, you should have a
total of 12 screws as well as 3 lose front
plates.
