11
10
Pilots Manual for Parajet Maverick Lite Trike - © 2022 Parajet International Ltd
Pilots Manual for Parajet Maverick Lite Trike - © 2022 Parajet International Ltd
Tilt the Maverick paramotor frame forward. Align each
clamp over the Maverick cage spar located next to the
harness arm. Push the connector fully onto the spar. Repeat on
opposite side.
Move quick release lever downward to open
[1]
. Turn the
lever anti-clockwise to unthread the clamp
[2]
and rotate
upward to remove from its housing
[3]
. Repeat on opposite side.
1
2
Rotate clamp downward to locate back into housing. With
the quick release lever open, turn the lever clockwise to
tighten the clamp until you feel resistance. Once tight, push the
lever into the fully closed position parallel to the brace arm tube.
Taking hold of the Maverick chassis frame, lift the paramotor
upwards and forward towards the front of the trike. Locate
the fuel tank crossbar firmly onto the support plate at the rear of
the trike, making sure the paramotor is positioned centrally.
3
4
Secure Maverick to Trike. Move quick release lever to open.
Place frame upright into the clamp and adjust to the proper
tension. Continue tightening clamp until you feel resistance.
Move lever to fully closed position, perpendicular to the clamp.
Initial setup only
. Using a 6mm Allen key, loosen the retaining
hex bolt on the mounting clamp. Slide up or down the rear
axle until the correct clamping alignment is achieved.Securely
tighten the hex bolt to lock clamp into position.
5
6
In early 2022, the two-part split connector system was superseded by a quick-release
clamp system.
The following fitment instructions are for those pilots that have been
provided with this method of airframe attachment… To begin, place the Maverick behind
the trike chassis, between the rear axles and with the harness arms orientated towards
the front of the trike chassis.
BUILD MY LITE TRIKE
FITTING THE MAVERICK
[FEB 2022 ONWARDS]
1
2
3
Summary of Contents for MAVERICK
Page 1: ...LITE TRIKE MANUAL...
