8
13
2) Part setting the panel
The Entry/Exit tone volume will be reduced for any part setting
Part set 1 (e.g. downstairs only armed):
Enter
or
Part set 2 (e.g. upstairs only armed):
Enter
or
Part set 3 (e.g. whole house armed except garage):
Enter
3) Unsetting the panel
The panel can be unset by entering the building via the entry exit route and then
keying either of the two User codes.
4) Activating the personal Attack Alarm (PA)
To activate the Personal Attack Alarm enter
5) Activating the Fire Alarm
To activate the Fire Alarm
6) Turning Chime On and Off
Panel must be in ‘day’ mode
Enter
The status of the chime facility is indicated by the ‘Chime’ LED on the front of the
control panel. When the chime mode is selected a two tone chime will be produced
by the internal sounder and any extension speakers when an Entry / Exit zone is
activated. The same key sequence can be used to turn off the chime facility.
7) Reading Event Log
Panel must be in ‘day’ mode
Enter
The ‘Day’ led will flash and the most recent event stored in the log will be displayed. If
the up arrow key is pressed the previous log entry will be displayed. Similarly if the
down arrow key is pressed the next most recent entry will be displayed.
The event log can be scrolled backwards and forwards using the up and down
arrow keys to allow the last 18 events to be viewed. To leave this function press the
key.
An error tone will be produced if an attempt is made to scroll outside either end of the
event memory.
55.
Panel Unset / Day mode.
Alarm and Fire Lights flashing,
This event will take place under two
conditions. i.e:
1.
If
has been entered. (Instant Fire Alarm)
2.
If any smoke detectors, connected to the
system, have been triggered.
To stop audible alarm and clear LEDs :
Enter
or
Master User code Limited User Code
88.
Panel unset / Day mode.
Fault supply and Day lights are on,
indicating that a mains failure has taken place.
Check tahat there is mains power elsewhere on
the premises.
If not, wait for mains power to return.
If there is mains power, contact your installation
company.
8
8
66.
Panel unset / Day mode
Alarm and Tamper lights flashing, indicating
that a Tamper alarm has taken place.
To stop audible alarm and clear LEDs :
Enter
or
Master User code
Limited User Code
Now try setting the system.
If the system goes straight into an alarm
condition contact your installation company.
77.
Panel unset / Day mode.
Fault light flashing, indicating that the panel
is in Engineer's Mode.
To exit Engineer's Mode,
Enter
Engineer code
RDOC 280 issue1
RKP
RKP
RKP
RKP