Note: Mount only in a vertical position! For cold water use only!
Installation under sink
Step 1
：
Install faucet. Dig a hole at the appropriate place in the sink, put the faucet into it and fix it.
Step 2:
Install T-adapter. Shut off the water. Turn on the kitchen faucet to release pressure and allow water
to completely drain from the line. Disconnect the valve of cold tap water. Then screw the T-adapter onto it.
Finally, Screw the cold water supply line to the T-adapter.
Step 3:
Mount the system head. Remove the cap from the top of the system head. Using the built-in
bracket on the back of the system head as template, mark the holes for the mounting screws on the wall
surface. Drill two pilot holes for the mounting screws. Insert mounting screws into the wall. Hang the
system head on the eyes of the bracket and replace the system head cap.
Step 4:
Install 1/4" plastic tubing for water supply line from T-adapter to system head inlet.
Step 5:
Cut plastic tubing squarely on both ends. Install 1/4" plastic tubing for water supply line from
system head outlet to faucet.
Note:
Do not bend or crimp 1/4" plastic tubing when inserting. Do not over tighten the compression nut.
Make sure there is no leak.
Summary of Contents for PW2000F
Page 4: ......
