Paradyne Hotwire 8786, User Manual

Page: 80 / 112

A. Configuration Options
A-6
February 2001 8786-A2-GB20-20
Time Slot 16
Possible Settings: Signaling, Data
Default Setting: Signaling
Specifies whether the G.703 interface is used for voice or data.
Signaling – Time slot 16 is used for signaling (the unit is in voice mode).
Data – Time slot 16 is used for data (the unit is in data mode).
NOTE: For associated DSL line rates and payload rates refer to Table 3-1, Fixed Rate
Payload Rates and DSL Line Rates, in Chapter 3, Initial Startup and Configuration.
Send (AIS) on Network Failure
Possible Settings: Enable, Disable
Default Setting: Enable
Specifies the action taken on the signal transmitted to the G.703 when a valid signal
cannot be recovered from the network interface (LOS or OOF).
Enable – An Alarm Indication Signal (AIS) is sent to the DTE in the event an LOS or
continuous OOF condition exists on the network interface.
Disable – The failed signal on the interface is sent to the DTE in the event an LOS or
continuous OOF condition exists on the network interface.
Primary Clock Source
Possible Settings: Internal, G.703
Default Setting: Internal
Determines the primary clock source for the unit in Bypass mode.
„
Primary Clock Source is available only when the unit is configured as an LTU.
Internal – The clock source is derived from the internal oscillator.
G703 – Specifies the unit’s G.703 interface as primary clock source.
Secondary Clock Source
Possible Settings: Internal, G.703
Default Setting: Internal
Determines the secondary clock source for the unit.
„
Secondary Clock Source is available only when the unit is configured as an LTU.
Internal – Clocking is derived from the internal oscillator.
G703 – The unit’s G.703 interface is the secondary clock source.
Table A-2. G.703 Interface Options (2 of 2)