![background image](http://html1.mh-extra.com/html/paradyne/hotwire-8610-dslam/hotwire-8610-dslam_installation-manual_754032048.webp)
A. Pinouts
A-4
April 2001
8610-A2-GN20-10
Telco 50-Pin Connector Pinouts for DSL Loops and POTS Splitters
The three Telco 50-pin receptacles on the rear of the
chassis (labeled for Slots 1, 2, 3) provide the 2-wire loop
interface from each DSL port to either the POTS splitter
card or, if the loop is not being shared with POTS, then
to the Main Distribution Frame (MDF). The following
table lists the pin assignments for each of these
interfaces.
NOTE:
When the 8610 chassis is the base chassis, the MCP is installed in Slot 1 and
the Tips and Rings for Slot 1 are not connected internally and are not active.
CONN #
for Slots 1–3
CONN PINS
(Tip, Ring)
CONN #
for Slots 1–3
CONN PINS
(Tip, Ring)
Port 1
1, 26
Port 14
14, 39
Port 2
2, 27
Port 15
15, 40
Port 3
3, 28
Port 16
16, 41
Port 4
4, 29
Port 17
17, 42
Port 5
5, 30
Port 18
18, 43
Port 6
6, 31
Port 19
19, 44
Port 7
7, 32
Port 20
20, 45
Port 8
8, 33
Port 21
21, 46
Port 9
9, 34
Port 22
22, 47
Port 10
10, 35
Port 23
23, 48
Port 11
11, 36
Port 24
24, 49
Port 12
12, 37
Port 25
25, 50
Port 13
13, 38
26
97-15526
50
1
25
Summary of Contents for HOTWIRE 8610 DSLAM
