Paradyne COMSPHERE 3550 Series, User Manual

Page: 71 / 153

Configuring the Unit
5-3 3550-A2-GB20-40 July 1999
Saving Configuration Options
CAUTION
Be extremely careful when
saving configuration options
to avoid saving them to the
wrong location.
To save edited configuration options:
"
Procedure
1. From any configuration option in any option set,
press the key to return to the Edit/Save
submenu.
2. Press the F1 key below SAVE.
3. Select area (Activ, Remt, Usr1) on the Save to
screen.
•
If Activ is selected, your changes take effect
immediately.
•
If Usr1 is selected, your changes are stored for
future use.
•
If the unit is a control and Remt is selected, the
complete set (all option sets available to the
unit) of configurations are sent to the tributary
and saved to its Activ area.
Remember that you cannot save to the factory-
loaded configurations.
Example Using the DCP
In this example, load the configuration options stored
in the PTPT area, change Diagnostic Type (Diag Type)
under the Diagnostic (DSU) option set from Disr to
NonD, change DTE Port under the General option set
from EIA232 to V.35, then save the changes to the Usr1
area, and return to the main or top-level menu.
"
Procedure
Press the DCP keys indicated by the shading.
F1
Port 1 DSU 9.6 C
Local Remot
F2 F3
F1
Local Mode:
Stat
Bckup Test
F2
F3
F1
Local Mode:
Bckup
Test Confg
F2 F3
F1
Configure:
Opts
PList Dir
F2 F3
F1
Load from:
Activ
Remt Usr1
F2 F3
F1
Load from:
Remt
Usr1 PTPC
F2 F3
F1
Load from:
Usr1
PTPC PTPT
F2 F3