Paradox Esprit E55, Programming Manual

Page: 5 / 48

Esprit E55 / E65 3
Decimal and Hexadecimal Values
Codes and Panel Reset
Viewing Version Numbers
Value or Action What Do I Press?
What Do I See?
10-zone LED 32-zone LED
Value 0 / Replace Current
Digit with 0
[
SLEEP
] Erase digit and remain in section Erase digit and remain in section
Values 1 to 9 [1] to [9] Erase digit and remain in section Zone 1 to 9
A (hex only) [0] Keys 1 to 9 Zone 10
B (hex only) [
OFF
] Key 0(10) Zone 11
C (hex only) [
BYP
] OFF Zone 12
D (hex only) [
MEM
] BYP Zone 13
E (hex only) [
TBL
] MEM Zone 14
F (hex only)
[ ]
TBL Zone 15
Exit Without Saving [
CLEAR
]
[ ]
A
RM
& S
TAY
LED flash
Save Data (hex only) [
ENTER
] A
RM
& S
TAY
LED flash Advances to the next section
Installer Code (Default: 0000 / 000000) The Installer code is used to enter programming mode, which allows you to program everything
except user codes. To change the default code, go to section [397] on page 31 and refer to sec-
tion [701] option [1] on page 31.
Maintenance Code (No Default) The Maintenance code is used to enter programming mode, which allows you to
program everything except for user codes and communication settings (sections [395], [397],
[398], [815], [816], [817], [910], and [911]). To set the default code, go to section [398] on
page 31 and refer to section [701] option [1] on page 31.
System Master Code (Default: 1234 / 123456) The System Master code can use any arming method and can program user codes. To change
the default code, go to section [399] on page 31 and refer to section [701] option [1] on
page 31.
Panel Reset
Before powering-up the panel, connect a wire from the zone 1 input to the PGM input. Power up
the panel and wait 6 seconds. Remove the wire and the panel will be reset to default.
Example:
Version
0 1.42 .
Digits 1-4
NOTE: K10V/H / K636 keypad version numbers cannot be viewed.
Step Action Details When Viewing Keypad Version
1 Enter Viewing Mode:
-For
panel version , Enter section [980] .
-For keypad version , Enter Installer Programming,
then press and hold [
ARM
] .
The first digit is displayed
(usually “0”) Digit 1
D
[
ARM
] is illuminated
2 Press [
ENTER
] The second digit is displayed. Digit 2
D
[
SLEEP
] is illuminated
3 Press [
ENTER
] The third digit is displayed. Digit 3
D
[
STAY
] is illuminated
4 Press [
ENTER
] The fourth digit is displayed. Digit 4
D
[
OFF
] is illuminated