Paradox Esprit 738 Express+, Programming Manual

Page: 10 / 13

Note: Do not use the Intellizone feature and an entry delay for the same zone, otherwise an alarm may occur as a user
tries to disarm the system.
KEY ACCESS PROGRAMMING
Programs features quickly, without entering addresses or section numbers.
To activate “key access programming”, press
[
ENTER
] , followed by installer, master or user code 1. (Code required depends
on the feature you wish to access - see below.) Press the key corresponding to the desired feature.
Press
[
ENTER
] or [
CLEAR
] to exit.
key
[8]
Installer test mode (installer code only)
In installer test mode, a confirmation beep (intermittent) indicates test is "on", a "rejection" beep (long) indicates
test is "off". The bell will squawk during walk testing to indicate opened, functional zones.
[9]
"Auto arming" time program (all 3 codes)
Key [9] flashes. Enter two digits (00 to 23) for hours + 2 digits (00 to 59) for minutes.
[
MEM
]
"Panel time" and clear "trouble 8" (all 3 codes)
Key [
MEM
] flashes. Enter two digits (00 to 23) for hours + 2 digits (00 to 59) for minutes.
[
BYP
]
Test report (all 3 codes)
Reporting is enabled at address 086 , keys [11] , [12] . A value must be entered at address 512 , and both telephone
and account numbers must be programmed.
[
TRBL
]
Call Espload via telephone (all 3 codes)
Panel identifier and PC password (addresses 004-007 ) and computer telephone number (addresses 008 - 015 ) must
be programmed.
[
AWAY
]
Answer Espload (all 3 codes)
This feature is available when using the ADP-1 adapter. In Espload, "blind dial" must be activated in "modem
setup" section, and panel phone number programmed (works also without ADP-1).
[
STAY
]
Cancel communication attempts (master code and user 1 can only stop calls to Espload)
Until next reportable event (installer code - all communications)
When communicating with Espload, it is impossible to enter programming mode.
10