"
ARM ONLY
"
CODE:
This code can only be used to arm the system. No other system fea-
tures can be accessed, and the system cannot be disarmed using the
"Arm Only" code, unless it is used during the exit delay period.
Deleting a user code:
Pressing the
[2
ND
]
key +
[
ENTER
]
, while in programming mode at any
user code address, will delete that user code.
ARMING THE SYSTEM
The user-friendly Esprit 727 can be armed in 5 different ways
designed to cover a wide variety of security situations. We suggest
that you familiarize yourself with all 5 arming procedures so that you
can take full advantage of your control panel.
(1)
REGULAR system arming
(used for normal, day-to-day system operation)
The keypads green "
READY
"
light must be "on" in order to arm the
system. This light will only illuminate if all protected zones are closed.
All doors and windows must be closed, and there can be no move-
ment in areas monitored by motion detectors. Once the "
READY
"
light
is on, enter your user code. (The installer will program all user codes
and code priorities for you.) If you make a mistake entering your
code, the keypad sounders
END
/
REJECTION
beep will let you know.
Just press
[
CLEAR
]
and re-enter the code. When you have correctly
entered your user code, the red "
ARMED
"
light will come on, and you
will hear the keypad "
CONFIRMATION
" beep. The "
READY
" light will flash
during the exit delay period. Your installer will program exit delay
duration based on the time you require to safely exit the protected
area once the system is armed.
Important:
Please note that when entering user codes, the
[10]
key
represents the digit 0.
(2) STAY arming
[
STAY
]
+
MASTER CODE
OR
USER CODES
1, 2, 3
(partial system arming)
"
STAY
" arming allows you to remain in the protected area while "par-
tially" arming the system. This means that you can stay in and move
around your home or commercial building, while certain designated
zones are armed and still receive the protection of your security sys-
tem. You might choose to have entry/exit points like doors or windows
protected, or the basement, or perhaps all the zones on the perimeter
of your home or establishment. Based on your instructions, your
installer programs the control panel to bypass these zones in "stay
arming" mode. These programmed "stay" zones can only be changed
during zone definition programming. (Please remember that
fire zone
7 and keypad zone 8 cannot be bypassed
.) Entering
[
STAY
]
+
MAS
-
TER CODE
or [
STAY
]
+
USER CODE
1
(
2
OR
3
) on the keypad activates the
"stay arming" command. "
STAY
" arming can also be activated by a key
switch - please refer to section on "key switch/push button arming".
(3) FAST arming
K
EY
[10]
(One touch system arming - no code required)
Fast arming (
regular
mode). When the "
READY
" light is on, pressing
key
[10]
steadily for 2 seconds will automatically arm the system. No
user code is required. This feature can be used to enable specified
individuals like service personnel (i.e. cleaners, maintenance) to arm
the system when leaving the protected area, without giving them
access to any other control panel operations. ("
FAST ARMING
" must be
activated by your installer during "panel option" programming.)
Fast arming (
stay
mode). When activated, no "
READY
" light is required
to arm the system. Pressing key
[10]
for 2 seconds automatically
"
STAY
" arms the system. (See "
STAY
" arming features described
5
4
UM727
UM727
