Listen
Every time a key is pressed, it illuminates and the keypad beeps (0.5
second tone) to show that the entry has been recognized. When you
enter information on the keypad, it will guide you with beep tones that
communicate acceptance or rejection of your entries. You should be
familiar with these two keypad beep tones:
"
CONFIRMATION
" beep: When an operation (i.e. arming/disarming) is
successfully entered on the keypad, or when the system switches to
a new status/mode, the sounder produces an
intermittent
beep tone.
"
END
/
REJECTION
" beep: When the system reverts to previous status, or
when an operation is incorrectly entered on the keypad, the sounder
emits a
continuous
beep tone.
Code priority
When deciding who should have access to your security system con-
trol panel, please keep in mind that each of the Esprit 727 master and
user codes has been assigned a code priority. Code priority deter-
mines the level of security access each user will have, and which fea-
tures and functions they can activate. The Master User Code ("prior-
ity 2") can arm/disarm the system, activate zone bypassing, and
reprogram master and user codes. User Codes 1-3 ("priority 3") can
be used to arm/disarm the system, activate "
STAY
" and "
AWAY
" arming,
and zone bypassing. User Codes 4-6 ("priority 4") can arm/disarm the
system and User Code 7 ("priority 5") is an "arm only" access code.
Master and User Code programming:
The Esprit control panel can be programmed to accept up to 7 user
codes. Depending on your security requirements, you can choose to
use either 4 or 6-digit access codes with your system. 6-digit codes
are considered more difficult to "crack" and are therefore viewed as
more "secure". If, however, ease of recall is your priority, then 4-digit
access codes can be programmed instead.
Your installer will program the Esprit to accept 4 or 6 digit codes, and
can also program the values for these codes. If you wish to create or
change the codes yourself, you may do so by following the steps indi-
cated below. The master code must be used to enter programming
mode to program user codes.
To program the master and all user codes:
Press
[
ENTER
]
+ master code + 1 digit access code new 4
or 6 digit code +
[
ENTER
].
Note
: If only 2 or 4 digits are entered, digits "00" will be enter auto-
matically in the remaining memory space.
Master code:
[1]
(priority 2) Arm, Disarm, Bypass, Away, Stay,
reprogram master and user codes
User code 1:
[2]
(priority 3) Arm, Disarm, Bypass, Away, Stay
User code 2:
[3]
(priority 3) Arm, Disarm, Bypass, Away, Stay
User code 3:
[4]
(priority 3) Arm, Disarm, Bypass, Away, Stay
User code 4:
[5]
(priority 4) Arm, Disarm
User code 5:
[6]
(priority 4) Arm, Disarm
User code 6:
[7]
(priority 4) Arm, Disarm
User code 7:
[8]
(priority 5) Arm
ONLY
3
2
UM727
UM727
