20
•
Double Side Burner Assembly
GSL-SB2B Double Side Burner Operator Manual
4.
Lift the burner unit into place:
a.
Position the burner unit so it is two thirds of the way into the cut-out with the outside edges
resting on the cut-out edges
Figure 12 Position Double Burner into Place
b.
Ensure the gas line and electrical cable are inside the open cut-out space
c.
Ensure nothing is binding below the burner unit
d.
Slide the burner unit all the way back into place in the cut-out
5.
Check to ensure the burner unit is level and properly supported around the entire outside edge of
the cut-out
•
If the burner unit is not level or is unstable, use non-combustible shims under the outside lip to
level and stabilize it
•
Proper leveling of your burner unit is essential to its safe and proper operation; a non-level
burner unit will result in erratic burner combustion, and inefficient, uneven heating
6.
Pull the drip pan out slightly and remove the protective covers from each side (Figure 13)
Figure 13 Drip Pan Protective Covers