P300H
P300 Modem Installation and Operating Handbook
Page 51
Setup: 1:Initial Config 2:Check
Memories: 3:Store 4:Recall 5:Erase
Setup Menu
Change: 1:Tx 2:Rx 3:Terr-Intfc
4:Rem M&C 5:User-Opt 6:Time/Date
Change Menu (local control)
Change limited as Remote M&C active !
Change: 1:Rem M&C 2:Time/Date
Change Menu (remote M&C)
6.4
SETUP - INITIAL CONFIGURATION MENU
When delivered, or if the non-volatile memory should ever be cleared, the unit must be completely
configured using the
SETUP, INITIAL CONFIG
option. This takes the operator through all the sections of the
CHANGE
procedure described below to ensure all parameters are set. Only when '
SETUP, INITIAL-
CONFIG
' has been performed once can
STATUS
be selected from the main menu. This ensures operation
is not selected until all critical parameters are specified.
Other options on the
SETUP
menu are:
CHECK
:
Which allow the setup to be checked, and looks for unusual combinations of
configuration parameters (eg IBS with rate
I
FEC coding, multiple scramblers
selected). Check does not prevent operation with any configuration, it is simply
a convenience for the operator if there are configuration difficulties. The Setup
Check takes several seconds to run and displays a message when the process
is complete.
MEMORIES:
STORE, RECALL
, and
ERASE
which allows access to the configuration memories
of the Modem. The current configuration can be stored, another recalled, or an
old stored configuration deleted. This provides a fast method of switching
between multiple configurations when required.
6.5
CHANGE MENU
It is under the Change menu that individual parameters may be varied after an initial
SETUP, INITIAL-
CONFIG
has been performed. If the unit is operating under Remote M&C, the options on the change
screen are limited to only the remote M&C configuration & the time/date:
Normal Change Screen (local control):
Change Screen (Remote M&C):
Each of these options will be described in the following sections:
