SNMP-NET
5
Chapter 2 Installation
Note:
The SNMP-NET cards are designed to be Hot Swappable, but there is a remote chance
that when Hot-Swapping the SNMP-NET card that the UPS will shutdown. MINUTEMAN
recommends following steps 1 through 8 when installing the SNMP-NET card, but to hot-swap,
skip to step number 3 and omit steps 6, 7.
1. Turn off all the equipment that is plugged into the UPS.
2. Turn off the UPS and unplug the UPS’s power cord from the AC wall outlet.
3. Remove the Option Slot cover plate from the rear panel of the UPS.
4. Insert the SNMP-NET in to the option slot and secure with the retaining screws.
5. Connect the SNMP-NET device to your LAN.
6. Open the Internet browser and link to the SNMP-NET device by typing the default host name
“
SNMP-NET
” in the address box.
7. Login as administrator with “
admin
” for the user and “
password
” for the default password.
8. Open the “User Manager” page to manage your accounts and passwords.
9. Switch to the “System Configuration” page and change the default Host Name.
10. Configure the IP address, Subnet Mask, Gateway IP for SNMP-NET device. If there is no
DNS server then you need to assign an IP address for the mail server if you want to be
notified e-mail.
11. We recommended disabling the BOOTP/DHCP option and assign a valid static IP address.
12. Open the “Time Server” page to synchronize the SNMP-NET device and the Time Server.
Please refer to next section on how to construct your SNTP server.
Note:
If you do not have a BOOTP/DHCP server in your LAN then follow below:
13. Make sure both of the SNMP-NET device and your workstation are in the same LAN.
14. Open EzSetting from the CD, and refer to next chapter for configuring SNMP-NET by
EzSetting.
15. Change the Host Name, and the IP Address.
16. Disable the BOOTP/DHCP option in the System Configuration group.
17. Please refer to next Chapter “Configuring the SNMP-NET by EzSetting” section for more
detail information on configuring the SNMP-NET.
Chapter 3 Configuration
The easiest way to configure the SNMP-NET is by running the EzSetting program. You can
find the program on the CD. Please see the sub-section below for more information.
If you have configured the essential network parameters successfully, you can launch the
Internet browser or telnet to the device. The first thing is to open the User Manager page and
change your account and password.
