Subjec t to c hange without notic e
290297
Page 11/20
Pr og r a mmi ng
a )
Set "Program" switc h on front panel to "on". Use manual c ontrol switc h to selec t the c olumn height
that will serve as starting point. Press the key marked STF to enter the first point (starting point) in
the program memory. (When STF is pressed, only the starting point is memorized, and any existing
programs are erased.)
b )
Use the manual c ontrol switc h to bring the c olumn to the next desired point (= first stopping
point). The Panther elec tronic s will memorize only the highest speed used to reac h this point
manually, and will repeat the move at this speed throughout. If you wish to program a slower
movement, you must drive slowly to the stopping point.
c )
You may drive up or down to any stopping point until it is entered. Enter the point by pressing
STM.
Note: Stopping point will only be rec orded when the c olumn is c ompletely stationary. To be quite
sure of c orrec t entry of any point, always wait a moment before pressing STM.
d )
Move to the sec ond stopping point and enter it by pressing STM. Any of up to 255 stopping
points are entered by always pressing STM.
e)
Before rec alling or resetting the program in sequenc e, move to the starting point by pressing GRF.
The c olumn automatic ally returns to this point at the maximum speed c hosen with the speed
selec tor.
f)
To rec all the program, press A (Ac tion) for every movement in c hronologic al order.
Note: For safety reasons, set "program" switc h on the front panel to "off" when not using programming
mode. This will not erase programmed movements; these are reac tivated when "program" switc h is set
to "on".
