Suzhou Pangolin Robot.Corp.,Ltd
29
network power supply, wait for the charger to stabilize for 2-3 seconds, and then insert the charger output port into the charging hole on the
back of the robot to start charging.
When using the charging pile to directly charge the robot, please place the charging pile against the wall first, insert the charger network
power plug into the network power supply, wait for the charger to stabilize for 2-3 seconds, then plug the charger output port into the side of the
charging pile to charge. When the robot detects that the battery is low, it will automatically return to the charging station for charging.
9.2 Wheel Cleaning
When the robot is walking, debris will inevitably stick to it, which will affect the service life of the motor. Please clean up in time.
Chapter 10 Packing and Handling
10.1 Short-distance Transportation (including chartered vehicles in the city)
On level concrete or the ground, the robot can be manually pushed to walk, and the walking speed should not exceed 15 m/min. It is strictly
forbidden to push the machine to walk when the robot is powered on or at work.
When loading and unloading trucks, going up and down stairs or steps (above 2mm), slope (above 10°), and crossing outdoor asphalt
pavements, please use our company's special packaging. Pay attention to the following operating specifications and steps, fix the robot on the
special handling tool, and then carry out the corresponding handling and loading and unloading work.
1
、
Fixed special transportation vehicles.
2
、
Two adult men (above 1.6 meters tall) support the bottom of the box with one hand and the middle of the box with the other from both sides
of the robot, and at the same time raise them 15~25cm for a period of time, and move them to the top of the special handling tool. And place
them on the tool plane.
3
、
Two adult men (above 1.6 meters in height) from both sides of the robot, holding the bottom of the packing box with one hand and the
middle of the packing box with the other hand, while lifting and getting on and off the car on the car and on the steps.
4
、
When loading and transporting, the height inside the vehicle must be greater than 1800mm, and the robot and the truck inner box must be
fixed with ropes. The machine and the inner wall of the carriage, and between the machine and the machine, need to be filled with 2cm thick
foam cotton to prevent bumps.
10.2 Long-distance Transportation (including logistics transportation, chartered vehicles)
Transportation needs to use the special packaging outer box and fixed filling method provided by our company.
