September 2022 7
VeriSafe Network Module User Guide, B21176 rev 1 [English]
NETWORK MODULE SETTINGS
FIGURe 6
. NETWORK MODULE SETTINGS CARD DETAILS
SAVE SETTINGS AND RESTART
Saves modified settings and restarts
the network module .
REFRESH
Replace all data in fields with the
last saved settings .
RESTART
Restart the network module without
saving changes to settings .
FACTORY RESET
Reset the network module to factory
default settings (see Table 4) .
NOTE: If the web application is
unavailable, the network module can
be physically reset by depressing the
User Reset Button (see Figure 1 for
location on the Network Module) .
1.
Refresh
Replace all data in fields with the last saved settings
2.
Date & Time
Displays current date and time associated with the network module .
3.
Set Time
Applies local web browser time to the network module .
4.
Network Module FW Version
Firmware version of the network module
5.
Use NTP server
Check to enable the use of NTP (Network Time Protocol)
6.
NTP server address
Enter server address to set time using NTP . Editable if
Use NTP Server
is checked .
7.
Power System Configuration*
Configuration of the power system that the AVT is monitoring . To report accurate voltage data,
the power system configuration must be selected . Default is Standard wye/delta *
8.
Modbus
Enable or disable the Modbus TCP interface (default enabled)
9.
EtherNet/IP
TM
Enable or disable the
EtherNet/IP
TM
interface (default enabled)
10.
DHCP
Enable or disable DHCP (default disabled)
11.
IP Address
Netmask
Gateway IP
DNS1
DNS2
Current IP address, Netmask and Gateway IP (read-only when DHCP is enabled)
DNS1 & DNS2 are always editable
12.
Web Server Mode
The web server can be configured for either HTTP or HTTPS (default is HTTP)
Continued on next page
