AT-OME-PS62
13
Installation
Connection Instructions
IP Modes
1.
Connect compatible HDBaseT transmitters (e.g. AT-OME-EX-TX) to the HDBaseT input ports.
2. Connect HDMI and USB-C sources to the HDMI and USB-C input ports.
3. *Optional* Connect 2CH sources to the analog AUDIO IN ports.
4.
*Optional* Connect a MIC or line input to the MIC/LINE input port and use the dip switch to ensure the port is in
the correct mode.
5.
*Optional* Connect the 2CH analog AUDIO OUT ports to an audio DSP, amplifier, or other audio distribution
devices.
6.
*Optional* Connect USB devices (e.g. USB camera) to the USB hub ports.
7.
*Optional* Connect the HOST USB port to a computer using a USB B to USB A cable (cable not provided).
8.
*Optional* For control, connect to the 3-pin captive screw RS-232 port.
9.
*Optional* Connect a network switch to the LAN port, for IP control or system configuration.
10. Connect an HDMI cable from the HDMI output port to a local display.
11.
Connect a compatible HDBaseT Receiver (e.g. AT-OME-EX-RX or AT-OME-SR21) to the HDBaseT output port.
12. Connect the included IEC power cord from the power port to a compatible power outlet.
Static
If no DHCP server is available, or a static IP is required, the OME-PS62 can be set to static IP mode using the IP
mode button.
•
Press and hold the
IP MODE
button for 5 seconds to switch to static IP mode, the LED will blink 2 times when it
goes into Static IP mode. In this mode, the AT-OME-PS62 will be set to the following:
IP address: 192.168.1.254
Subnet mask: 255.255.0.0
Gateway: 192.168.1.1
•
To switch back to DHCP, press and hold the IP mode button for 5 seconds. The LED will blink 4 times when
successfully put into DHCP mode.
DHCP
By default, the AT-OME-PS62 is set to DHCP mode. In this mode, when the AT-OME-PS62 is connected to the Local
Area Network (LAN), it will automatically be assigned an IP address by the DHCP server (if available). Press the IP
MODE button to show the IP address in the top left corner of the display connected to the HDMI output.
