Panduit Atlona AT-HDVS-SC-RX, Manual

Page: 15 / 41

AT-HDVS-SC-RX 15
7. Press the UP or DOWN cursor buttons on the front panel to toggle between Dhcp and Static .
8. Press the ENTER button to set the desired IP mode.
When set to Static mode, each byte of the IP address can be set: Press the UP or DOWN cursor buttons to
highlight the desired field, then press ENTER to select the field. Press the UP or DOWN buttons to change the
byte value. Press the ENTER button to confirm the value.
Installation
Use the IPStatic and IPDHCP commands to switch between DHCP and IP mode through RS-232 or Telnet. Refer to
API documentation for more information. All commands and their arguments are case-sensitive.
• Setting static IP mode
1. Connect to the AT-HDVS-SC-RX using RS-232 or Telnet.
2. At the command line, execute the
IPDHCP
command using the
off
argument, as shown.
IPDHCP off
3. Execute the IPStatic command. This command requires three arguments: the desired IP address of the AT-
HDVS-SC-RX, the subnet mask, and the gateway address. All arguments must be entered in dot-decimal
notation. The following is an example:
IPStatic 192.168.1.112 255.255.255.0 192.168.1.1
• Setting DHCP mode
1. Connect to the AT-HDVS-SC-RX using RS-232 or Telnet.
2. At the command line, execute the
IPDHCP
command using the
on
argument, as shown. All characters are
case-sensitive.
IPDHCP on
Once DHCP is enabled, the unit will be assigned an IP address by the DHCP server (if present).
IP address Subnet mask Gateway
Setting the IP Address Using Commands
IP menu
IP Mode Static
Static Set IP
Byte1 High 192
Byte2 168
Byte3 1
Byte4 Low 254
Back
Exit