PA N D O R A T R A C E R
U S E R A N D I N S TA L L AT I O N MA N UA L
20
21
Installation/replacing SIM-card
w
arNiNg
! t
he
preiNstalled
sim-
card
is
paired
with
the
tracker
by
default
aNd
caNNot
work
with
other
devices
.
Make sure that a new SIM-card is working. Insert the SIM into your
mobile phone and check the following services: voice communication,
SMS, internet connection. Disable PIN request of the SIM.
1. Disconnect the main power supply from the tracker.
2. Unscrew all screws, carefully remove the cover from the tracker.
3. Press and hold VALET button for 10 seconds (10 short flashes of
the LED indicator), release the button (the LED will perform flashes
displaying Firmware update mode). During 1 minute install/replace the
SIM card observing correct direction. If the LED is not flashing (built-
in battery is discharged), installation/replacing of the SIM-card is not
limited by time.
4. Close the cover and screw all screws. Program the tracker with
Pandora NAV BT mobile application:
• “System phone number” setting – specify a new number of the
installed SIM card in the XXXXXXXXXXX.
• “Balance inquiry number” setting – Specify a command of the
“Balance request” corresponding to a mobile operator.
• “GPRS (APN) operator access point”, “GPRS operator username”, “GPRS
operator password” – enter APN settings of your mobile operator.
PROGRAMMING
At the time of delivery the tracker is in «Transportation» mode. The
tracker will exit this mode after setting of a main or additional phone
number.
Operation and configuration of the tracker is possible only when
there is power supply from the external source (main power supply) or
from the built-in battery:
- main power supply allows the tracker to operate in the «Constant
connection» mode. Connection of the ignition input enables «Tracking»
function;
- built-in battery allows the tracker to operate in «Autonomous
beacon» mode. In this mode the tracker is online once a day at 12:00
a.m. (default settings).
w
arNiNg
! t
he
tracker
will
activate
the
«t
raNsportatioN
»
mode
if
the
phoNe
Numbers
were
Not
set
or
deleted
from
the
settiNgs
aNd
the
maiN
power
supply
is
discoNNected
.
w
arNiNg
! b
efore
programmiNg
the
tracker
it
is
recommeNded
to
update
the
software
usiNg
the
p
aNdora
Nav bt
mobile
applicatioN
.
Setting the main owner phone number
There are three ways to set the main owner phone number:
1. Pair a mobile phone with the preinstalled Pandora NAV BT mobile
application (see the PANDORA NAV BT MOBILE APPLICATION section).
If the previously established Bluetooth connection was lost and the
