Pando PHT-941, Manual

Page: 82 / 332

INOXPAN S.L. EN - 6
When plugging the oven in for the first time, the logo will appear followed by 12:00 flashing on the
screen.
You must set the time in order to use the oven.
SETTING THE TIME:
 Select hours with the left knob and minutes with the right knob.
Validate the selection with the key or wait a few seconds.
 Select with the right control the type of graphic for the hour display.

Validate the selection with the key or wait a few seconds.
An audible signal will be heard confirming that the time has been set on the screen.
To change the time:
With the oven in standby (start screen), hold the button until the time begins to flash. Follow
these steps to change the time.
If the clock does not respond correctly when you touch the glass, unplug the oven for a few seconds
and then plug it in again. Doing this causes the sensors to adjust automatically and they will react
again to finger touch.
3. SWITCHING ON AND SETTING THE TIME
WARNING
The sensitivity of the touch controls continuously adapt to the ambient conditions. Make sure the glass surface of the control panel
is clean and free of any obstacles when plugging in the oven
.
WARNING
In the event of a power failure, your electronic clock/timer settings will be erased.
The time12:00 will appear.
You can set the time as described above.
If the oven door was locked before the power cut, the locked symbol will appear until it is unlocked.
This may take several minutes, depending on the temperature inside the oven, and during this
period you cannot reset the time.
Once the door is unlocked, you can set the time as described above.