Pando INOXPAN S.L, User And Installation Manual

Page: 82 / 104

EN - 82 INOXPAN S.L
7.7.2. Pando AIR Clean with remote control TOUCH RF.
Automatic Function Motor System
Automatic function renewing the air on minimum energy consumption and maximum comfort. Motor is set on
for 10 minutes every hour on first speed and during a cycle of 5 hours. By doing this the air in the room is
renewed on low sound level and automatically.
•
PANDO AIR Clean set on mode.
With the hood off, keep press “Timing” button during 3 seconds,
then as mode on set, pilot led light button will flicker in white, and motor will start on minimum speed,
being automatically set for a 5 hours cycle on 10 minutes mode each hour.
3”
White
•
PANDO AIR CLEAN set off mode. After the 5 hours program, the motor goes completely to a halt
and does not start up again. Should we need to set off the function before finishing the 5 hour cycle
press “ON/OFF”. With this function on, lighting can be on/off, but does not admit motor speed setting.
SATURATION OF FILTERS IN PILOT-BEEP AERIAL MODULE
The hood has a filter saturation warning system, which works through a 30-hour timer, which will emit a visual
colours signal warning that it is necessary to clean the filters.
After 30 hours of operation of the hood, when it is turned off, a warning signal will be displayed on the LED,
this visual signal is a cycle of colour change every second in the following sequence: white, light blue, dark
blue, red, dark blue, light blue and white ....
To switch off the warning and reset the hour counter to zero, pressing the engine or lights start button is reset.