15
Sheet-‐fed Scanning with Feeder Dock
Always place the feeder dock on a flat surface for scanning.
When the scanner is engaged in the feeder dock, no battery is required to operate.
1200 DPI mode is not supported when scanning with feeder dock.
Long (20-inch) receipt scan only in 300 DPI mode when scanning with feeder dock.
When the scanner is
off
and engaged in the feeder dock, the feeder dock charges the battery.
Scanning the same original in different orientations may produce scanned images that look slightly different in
color tones and brightness. This is not a malfunction.
CAUTION
: Insert only one original at a time, and insert the next original only when the
previous one is done, otherwise the feeder dock may malfunction.
CAUTION
: Do not scan glossy photos in humid environments
(humidity higher than 70% RH)
;
the surface of the photo becomes sticky and may cause the feeder dock to jam.
1.
(Optional)
Insert a microSD card
(not included)
in the card slot to expand your storage space.
2. Be sure Wi-Fi connection is off.
3. Insert the scanner into the feeder dock:
a) Press the latch.
b) Place the right end of the scanner into the
feeder dock and press onto the connector.
c) Press scanner down to snap under latch.
4. Insert the power adapter plug into the wall and
power connector on the end of the feeder dock.
5. Press
to turn scanner on.
If scanning a document rather than a photo, if desired, change the file format setting to PDF (see
the “Set the Scanned Image File Format” section on page 21).
6.
With the side to be scanned facing upward, place the left edge of the original straight
against the left edge of the feed slot, and then slide the guide lever against the right side
of the original.
7.
Gently insert the original into the feed slot; release it as soon as it begins to feed.
After the feed begins, the scanner pauses briefly and then completes the scan.
c
a
b