User Manual For Cyclone LC Programmers
51
Figure 6-4: Specify Target Architecture (NXP)
Figure 6-5: Specify Target Architecture (STMicroelectronics)
Note:
The user can still select an ARM-based device when using the NXP or STMicroelectronics
manufacturer selections.
6.1.1.3
Device Box
The Device box can be used to choose from any devices that have recently been selected.
Figure 6-6: Device Drop-Down - Select From Recently Chosen Devices
6.1.2
Security Settings - Qorivva (MPC55xx-57xx) Only
If your selected target architecture was Qorivva (MPC55xx-57xx), the Cyclone Image Creation
Utility will display an area called Security Settings (see
). If your MPC55xx-57xx device
supports uncensoring, click the “Device supports uncensoring” checkbox and select the
appropriate bit depth for the device’s password (64-bit or 256-bit). The box to the right is where the
password must be entered. Optionally you may use the Browse button to navigate to a text file that
contains the correct password for the device. The contents of the text file that you select will
automatically be used to fill the password text box.
Figure 6-7: Security Settings - Qorivva (MPC55xx-57xx) Only
6.1.3
Programming Sequence
This is the two-panel interface directly below the Device Selection area. This is where the user
creates the sequence of commands to be carried out during programming. The left panel provides
a list of available programming functions. The right panel displays the ordering of the functions.
