User Manual For Cyclone LC Programmers
31
*The pin is reserved for internal use within the PEmicro interface.
**The pin is reserved for internal use within the PEmicro interface only when using an MR8 target.
3.18.6
PORT F: 6-Pin Debug Connector (RS08, HCS08, HC(S)12(X), S12Z, Co/V1, STM8 w/
adapter)
The Cyclone provides a standard 6-pin 0.100-inch pitch dual row 0.025-inch square header for
ColdFire V1, S12Z, 68(S)12(X), 68HCS08, RS08, and STMicroelectronics’ STM8 targets. The
location of the this header is indicated as PORT F in
. The header uses the NXP
standard pin configuration, listed here for reference:
ColdFire V1, 68(S)12(X), 68HCS08, and RS08 Signals
PIN 1 -
BKGD
GND -
PIN 2
PIN 3 -
NC
RESET -
PIN 4
PIN 5 -
NC
TVCC -
PIN 6
S12Z Signals
Note:
* indicates optional signal
PIN 1 -
BKGD
GND -
PIN 2
PIN 3 -
PDO*
RESET -
PIN 4
PIN 5 -
PDOCLK*
TVCC -
PIN 6
6-Pin STM8 Signals
PIN 1 -
SWIM**
GND -
PIN 2
PIN 3 -
NC*
RESET -
PIN 4
PIN 5 -
NC*
TVCC -
PIN 6
*The pin is reserved for internal use within the PEmicro interface.
** All the signals are direct connect except the SWIM line which requires a 680 Ohm pull-up
PEmicro also offers a separate STM8 adapter (part# CU-CUFX-STM8-ADPT) that can be plugged
into the 6-pin header of the Cyclone (see
Figure 3-21
). The adapter offers 4 pins signals from an
ERNI connector.
4-Pin STM8 Signals
(Requires STM8 Adapter, sold separately)
PIN 1 -
TVCC
SWIM -
PIN 2
PIN 3 -
GND
RESET -
PIN 4
Figure 3-21: STM8 Adapter: 1) Bottom, 2) Top, 3) Connected To 6-Pin Header of Cyclone_Universal
(Adapter Sold Separately)
