User Manual For Cyclone LC Programmers
52
Figure 6-8: Specify Programming Sequence
There are two ways to create the programming sequence.
6.1.3.1
Manual Selection
The user can individually specify the algorithm and the object code and then add commands. To
specify the programming algorithm for the target, double-click on the Choose Algorithm (CM)
function in the left panel. Or, it can be highlighted and added it to the right panel using the arrow
(->). This opens the “Specify Programming Algorithm to Use” dialog.
Figure 6-9: Specify Programming Algorithm To Use
The user should select the programming algorithm to be used. Once the algorithm is selected, the
full list of programming functions becomes available in the left panel.
Figure 6-10: Programming Functions Available
Similarly, to specify the S-Record to be programmed into the target, the user may double-click on
Specify Object Code (SS) in the left panel or highlight it and add it using the arrow (->). This opens
a dialog which allows you to select the appropriate S-Record.
