Panasonic YW-50DNW, Operating Instructions Manual

Page: 8 / 20

3
6 Preparation for use
Fingers, hair, clothes, etc. close to the wire wheel and drive shaft and
other parts that may be involved in causing injuries.
Please carefully confirmed before the construction of rubber insulated cable
terminals are tightened too strong. Often caused by inadequate wiring welding
arc of instability, and even led to the breakdown terminals.
Set to use site
Please place the following conditions are met using the wire device.
The machine for indoor use machine, the protection class is IP2X.
Do not put a drop of water, rain fell on the places.
At the ambient temperature of -10
℃
to 40
℃
in the context of its use.
Do not set a strong shock or be hit on the counter.
The hanging wire devices use prohibited.
If indeed the use of conditions need to fly using this device, please separately purchase
and install a coil axis locking cover (TSMD0041) to prevent injuries caused by wire set off.
: L
ocking-type cover (TSMD0041) for the shopping goods disk axis.
Wire device supports between the shell and should be insulated. Or inclined position in the wire hanging
device, in the frame at the bottom of the four reserved φ7mm diameter hole to install spreader, and the
effective use M6 screws tightened to prevent loosening.
Spreader --- Please user-owned, pay attention to use enough to load-bearing.
Unit
：
[mm]
As shown
：
Install the spreader at
the four threaded holes with the
diameter of 4-M5 at the bottom of
the frame, and tighten them with
M5 screws to avoid loosening.