5
■Locking-type cover plate shaft TSMD0041 for use
When using wire hanging device must be used when locking a coil axis cover TSMD0041.
Install wire tray
:
a)
The wire plate retaining pin holes at the damping plate shaft retaining pin
,
set the wire
spool
;
b)
Plate shaft knurled screw the lid out of state in rotation, clockwise rotating disk shaft
cover, install it to disk axis damping
;
c)
Appropriate adjustments to disk drive shaft cover and wire the relative position of the
knurled screw aligned wire plate retaining pin holes and knurled screw to limit the cover
of freedom of rotation, to prevent them from damping plate axis, thus ensuring reliable
wire rotating disk.
Remove the wire tray: a note on the steps by reverse operation can be.
Damping
plate
shaft
Wire Spool
Shaft
cover
plate
Shaft cover plate
knurled screw
(
back-out
)
Wire
plate
retaining
pin hole
Damping
plate
shaft
retaining pin
①
②
③
Shaft cover plate
knurled screw (screwing in
)
Summary of Contents for YW-50DNW
Page 14: ...9 9 Overall dimensions ...
Page 15: ...10 10 Circuit diagram PCB ...
Page 16: ...11 11 Parts layout drawing ...
Page 18: ...13 12 Parts List ...