•
Default:
Frame rate
Note
•
When “Frame rate” is selected for “Transmission priority”, number of users who can access the camera
may be limited more (may become less than 10).
[Frame rate*]
Select a frame rate for H.264 images from the following.
1fps/ 3fps/ 5fps*/ 7.5fps*/ 10fps*/ 12fps* (E model)/ 15fps*/ 20fps*/ 30fps*
•
Default:
30fps*
Note
•
When “Frame rate” is selected for “Transmission priority”, this setting is available.
•
“Frame rate*” is restricted by “Max bit rate (per client)*”. For this reason, the frame rate may be lower
than the specified value when any value marked with an asterisk (*) is selected.
[Max bit rate (per client)*]
Select a H.264 bit rate per a client from the following. When “Best effort” is selected for “Transmission
priority”, set the maximum and minimum bit rates.
64kbps/ 128 kbps*/ 256kbps*/ 384kbps*/ 512kbps*/ 768kbps*/ 1024kbps*/ 1536kbps*/ 2048kbps*/ 3072kbps*/
4096kbps */ 8192kbps*/ Unlimited*
•
Default:
–
H.264(1): 4096kbps*
–
H.264(2): 1536kbps*
“8192kbps*” is available only when the image capture size is “1280x960” or “1280x720”.
SW155
SF135
“128kbps” is available only when the image capture size is “QVGA”, “VGA”, “800x600”
SW152
or
“320x180”, “640x360”.
“64kbps” is available only when the image capture size is “QVGA”, “VGA” or “320x180”, “640x360”.
“Unlimited*” is available only when “Frame rate” is selected for “Transmission priority”.
Note
•
When “8192 kbps*” or “Unlimited*” is selected, the number of users who can access H.264 images will
be limited to “1”. (Only a single user can access H.264 images.)
•
The H.264 bit rate is restricted by “Bandwidth control(bit rate)” on the [Network] tab on the “Network”
page (
®
page 111). For this reason, the bit rate may be lower than the value when any value with an
asterisk (*) on the right is selected.
•
It is impossible to select “Unlimited*” for both “H.264(1)” and “H.264(2)”.
[Image quality]
Select the image quality of H.264 images from the following.
Low(Motion priority)/ Normal/ Fine(Image quality priority)
•
Default:
Normal
Note
•
When “Constant bit rate” or “Best effort” is selected for “Transmission priority”, this setting is available.
[Refresh interval]
Select an interval (I-frame interval; 0.2 - 5 seconds) to refresh the displayed H.264 images.
If using under a network environment with frequent error occurrences, shorten the refresh interval for H.264
to diminish image distortions. However, the refresh interval may be longer than the set value.
0.2s/ 0.25s/ 0.33s/ 0.5s/ 1s/ 2s/ 3s/ 4s/ 5s
•
Default:
1s
Operating Instructions
67
11 Configure the settings relating to images [Image]
