19
Symptom
Cause/solution
Reference
pages
When the power is
turned on, the
STATUS indicator
lights or blinks
orange.
• Is the ethernet cable connected appropriately?
Connect the ethernet cable appropriately.
• Is the hub or router connected to the camera operat
-
ing appropriately?
Check if the hub or router in use is operating appro-
priately.
• Isn't the ethernet cable connected to the camera
broken?
Replace the cable with another one.
“Connecting”
in
Installation
Guide
STATUS indicator
keeps on blinking
orange approx. in 2
seconds intervals.
• UPnP
TM
error has occurred since the power is not
supplied to the router.
Turn on the power of the router. Wait until the con-
nections are established.
−
• An error has occurred during the port update by the
UPnP function.
If the router in use does not support the UPnP function,
perform the port forwarding setting for the router. In
addition, deactivate the setting of auto port forwarding
for the camera.
Operating
Instructions
(included in
the
CD-ROM)
• UPnP function of the router is disabled.
Refer to the operating instructions of the router to
enable the UPnP function.
−
STATUS indicator
never lights up.
• Is “Off” selected for “Indicator” on the “Basic” page?
Select “On” or “On(Access)” for the indicator setting.
Operating
Instructions
(included in
the
CD-ROM)
STATUS indicator
keeps on blinking red.
• The camera may be out of order.
Contact your dealer.
• Refer to the readme file on the provided CD-ROM for
further information after checking the displayed con-
tents of the “Maintenance” page - the [Status] tab -
“Self check” of the setup menu.
−
STATUS indicator
lights red.
• Camera is used in an inclined state. Re-check the
installation state, and confirm that it is installed
upright on the floor or hung straight from the ceiling.
Installation
Guide
