13
About SD memory card
• To remove the SD memory card from the
unit, press the [Setup] button on the “Live”
page, select the [SD memory card] tab,
and set the SD memory card operation to
“Not use”. Then, remove the SD memory
card. Alternatively, hold down the SD ON/
OFF button for about 2 seconds. When
the flashing SD MOUNT lamp goes out,
you can remove the SD memory card.
• When using an SD memory card, format it
using this product. Recorded data on the
SD memory card will be deleted when for-
matted. If an unformatted SD memory card
or an SD memory card formatted with
other devices is used, this product may
not work properly or performance deterio-
ration may be caused. Refer to the
Operating Instructions on the provided
CD-ROM for how to format an SD memory
card.
• When some SD memory cards are used
with this product, the product may not
work properly or performance deterioration
may be caused. Use the SD memory
cards recommended in page 28.
• When using an SD memory card support
-
ing Class 10 of the speed class, use a
UHS-I (Ultra High Speed-I) compliant card.
About the dehumidifying device
• This product has dehumidifying device to
keep the inside at low moisture level, pre-
venting condensation and quickly dissipat-
ing dew if produced.
•
Dew may be produced depending on the
conditions of temperature, humidity, winds,
and rain, and it may take time to dehumidify.
• Do not cover the surface of the dehumidi
-
fying device.
SFV781L
Dehumidifying
device
SPV781L
Dehumidifying
device
What to do if “WARMING UP-PLEASE
WAIT” appears on the display.
This message indicates that the temperature
inside the camera has become extremely low.
Wait until the internal temperature of the cam-
era rises (for around 2 hours or more in tem-
peratures below -20 ºC {-4 °F}), turn the power
off once, then turn it back on again.
