11.2 Configure the settings relating to JPEG images
[JPEG/H.264]
Click the [JPEG/H.264] tab on the “Image/Audio” page. (
®
IMPORTANT
•
When “Quad stream” is selected for “Image capture mode”, JPEG image settings are unavailable.
•
When “9M Fisheye” is selected for “Image capture mode”, “JPEG(2)” settings are unavailable.
•
When “On(NTSC)” or “On(PAL)” is selected for “Monitor out”, JPEG image settings are unavailable.
“Live” page (Initial display)
Configure the settings relating to the initial images displayed on the “Live” page.
[Initial display stream]
Select the image to display on the “Live” page from the following.
H.264(1)/H.264(2)/JPEG(1)/JPEG(2)
•
Default:
H.264(1)
[Refresh interval (JPEG)*]
Select an interval to refresh the displayed JPEG image from the following.
0.1fps/ 0.2fps/ 0.33fps/ 0.5fps/ 1fps/ 2fps/ 3fps/ 5fps/ 6fps*/ 10fps*/ 12fps*/ 15fps*/ 30fps*
•
Default:
5fps
Note
•
When “On” is selected for “H.264 transmission”, the refresh interval may be longer than the set value
when any value with an asterisk (*) on the right is selected.
•
Depending on factors such as the network environment, the resolution, the image quality, or the number
of computers concurrently accessing the camera, the transmission interval may be longer than the set
value.
•
If images are not delivered in the specified transmission interval, you can make the images be delivered
closer to the specified time by lowering the resolution or image quality.
JPEG
Configure the setting for “Image capture size” of “JPEG(1)” and “JPEG(2)” on this section. Refer to
page 97 for further information about the settings relating to H.264 images.
[Image capture size]
Select the image capture size to display the JPEG image. The image capture sizes that can be selected depend
on “Image capture mode”. For information on the image capture sizes that can be selected, refer to page 10.
•
Default:
JPEG(1):Fisheye/2992x2992
Operating Instructions
95
11 Configure the settings relating to images and audio [Image/Audio]
