13 Configure the alarm settings [Alarm]
The settings for alarm actions, alarm images, VMD areas, and alarm occurrence notifications can be configured
on this page. The “Alarm” page has the [Alarm] tab, the [VMD area] tab, and the [Notification] tab.
13.1 Configure the settings relating to the alarm
action [Alarm]
Click the [Alarm] tab on the “Alarm” page. (
The settings relating to the alarm can be configured in this section. Refer to page 137 and page 136 for further
information about the settings relating to the alarm images and the alarm output terminal.
Alarm
[Terminal 1]
Determine how to use terminal 1.
•
Off:
Not used.
•
Alarm input:
Receives alarms. When “Alarm input” is selected, a pull-down menu for “Close” and
“Open” is displayed.
–
Close:
An alarm is detected when the terminal status is changed to “Close”.
–
Open:
An alarm is detected when the terminal status is changed to “Open”.
•
Black & white input
SFV481
:
Receives the black & white switchover input. (When the input is set to On,
the black & white mode is activated.)
•
Default:
Off
[Terminal 2]
Determine how to use terminal 2.
•
Off:
Not used.
•
Alarm input:
Receives alarms. When “Alarm input” is selected, a pull-down menu for “Close” and
“Open” is displayed.
–
Close:
An alarm is detected when the terminal status is changed to “Close”.
–
Open:
An alarm is detected when the terminal status is changed to “Open”.
•
Alarm output:
Alarm output will be carried out according to the settings for “Alarm output terminal
setup” (
•
Default:
Off
134
Operating Instructions
13 Configure the alarm settings [Alarm]
