Installations/Connections
The following are descriptions of how to install the camera on a ceiling.
Before starting the installation/connection, prepare the required devices and cables.
Before starting the connection, turn off the power of the devices including the camera and the PC or disconnect from the
12 V DC power supply.
When installing the camera with using the ceiling mount bracket, the ceiling embedding bracket, or the wall mount bracket,
refer to the instructions included with those optional accessories.
Installing the camera on a ceiling
When installing the camera on a ceiling, there are two methods; wiring through a hole in the ceiling (
☞
page 16) and wiring
through a cable guide (unnecessary to make a hole in the ceiling) (
☞
page 20).
IMPORTANT:
• Procure 4 screws (M4) to secure the camera mount bracket (accessory) to the ceiling according to the material of the
installation area. In this case, wood screws and nails should not be used.
For mounting a camera on a concrete ceiling, use an AY plug bolt (M4) for securing.
(Recommended tightening torque: F1.6 N·m {1.18 lbf·ft})
• Required pull-out capacity of a single screw/bolt is 196 N {19.99 lbf} or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the area shall be sufficiently reinforced
or the ceiling mount bracket for the camera WV-Q105 (option), or the ceiling embedding bracket WV-Q126, shall be
used.
• Remove the cover film from the dome cover after the installation is complete.
• When using 12 V DC power supply, strip 3 mm to 7 mm {1/8 inches to 9/32 inches} from the end of the wire, and
twist the stripped part of the wire sufficiently to avoid short circuit, before installing the camera and connecting the
cables (
☞
page 19).
• Be sure to install the safety wire to prevent a fall of the camera resulting in injury or accidents in case the mount brack-
et (accessory) comes off. (Only for models that can be installed with a safety wire)
<When using the optional mount bracket WV-Q105>
Refer to the operating instructions about mounting method of the optional ceiling mount bracket for the camera,
WV-Q105.
Caution:
• FOR UL LISTED MODEL(S), ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY.
Safety wire angle
Anchor bolt
(Procured locally)
Safety wire
Camera mount bracket
(accessory)
Roof space
WV-Q105 (option)
Ceiling board such as plaster board
Decorative cover (accessory)
Camera
Mounting screws
(4 pcs : WV-Q105 supplied)
15
Summary of Contents for WV-SC386
Page 35: ...35 ...
