3
Periodic inspections shall be conducted.
•
Rust on the metal parts or screws may cause a fall of the product resulting in injury. Consult the
dealer for the inspections.
Do not rub the edges of metal parts with your hand.
•
Failure to observe this may cause injury.
Consult the dealer about the installation area to select a strong ceiling area. Make sure that the
•
installation area is strong enough to hold the total weight of the camera assembly (approx. 2.8 k
g
{6.13 lbs.}) before installation.
The installation area shall have 210 mm {8-9/32"} or more space behind the ceiling.
•
210 mm {8-9/32"} or more
Ceiling board: between 9 mm {3/8"}
and 40 mm {1-9/16"}
The thickness of the ceiling board for installation can range between 9 mm {3/8"} and
•
40 mm {1-9/16"}.
Avoid installing in the following locations.
•
Locations where it may get wet from rain or water splash (not only outdoor)
•
Locations where a chemical agent is used such as a swimming pool
•
Locations subject to steam and oil smoke such as a kitchen
•
Locations near flammable gas or vapor
•
Locations where radiation or x-ray emissions are produced
•
Locations subject to strong magnetic field or radio waves
•
Locations where it may be damaged by briny air such as seashores
•
Locations where the temperature is not within -10
C- + 50
C {14
F - 122
F}.
•
Locations subject to vibrations (This product is not designed for on-vehicle use.)
•
Locations where the temperature may rapidly change such as the peripheral areas of the air
•
outlets of air conditioners or doors facing outside. (In case of installing the camera in such
locations, the dome cover may become foggy or condensation may be caused on the
cover.)
The screws and bolts must be tightened with an appropriate tightening torque according to the
•
material and strength of the installation area. After tightening the screws or bolts, perform visual
check to ensure tightening is enough and there is no backlash.
