Usin
g
the Front Panel for Operations
51
11
Check the disk information.
Check the follo
w
ing content related to the HDD under [Disk
information] on the settings menu. Refer to the Setup
Instructions (PDF file) for more information.
•
HDD capacity
•
HDD remaining capacity
•
Hour meter
•
Disk operation mode
•
Date range of video recorded on the HDD
Note:
•
You cannot remove individual HDDs
b
y opening the front panel
w
hile operating in RAID5 or RAID6 mode.
•
Refer to page 53
w
hen replacing HDDs
w
ith errors.
Sets the HDD operation mode.
The initial setting is set to [SINGLE mode].
This setting is not necessary to use the single mode as it is set up.
1
Turn off the recorder.
Turn off the po
w
er according to "Turning Off the Po
w
er
(page 39)".
2
Turn on any extension units first if any are connected.
3
Insert the key (included) into the key hole and turn it
while pressin
g
in
g
ently to open the front cover.
4
Sets the operation mode with the [RAID] switch.
5
Hold down the [USE] button and turn on the power to
boot up.
•
The settings are ena
b
led at
b
ootup. Continue to press the
[USE]
b
utton until the
b
uzzer sounds.
Settin
g
the HDD's Operation Mode
S
: SINGLE mode (default)
R5
: RAID5 mode
R6
: RAID6 mode
Important:
•
The HDD operation mode cannot
b
e changed once the
system is operating. Recorded data may not
b
e read correctly
if the mode is changed after the system is operating.
(1)
(2)
[USE] b
u
tton
[RAID] switch
ND400_Basic.book 51 ページ ２００８年４月８日 火曜日 午後３時５９分
