42
43
Configure the advanced settings for recording and events [Advanced setup]
Configure the special settings related to recording on this tab. Set up the recording mode, alarm disarm dura-
tion and Panasonic alarm port number (the port number for incoming site alarm).
[Recording mode]
Determine whether or not to stop all recording
actions. Set to "Off", primarily to stop access to the
HDD before turning off the power.
On: Performs recording.
Off: Stops all recording actions.
Default:
On
Important:
• If "Off" is selected, be sure to return the setting to
"On" when resuming operation.
[Alarm disarm duration]
Set the period to suspend event actions for the case
that the same kind of event (terminal alarm, camera
site alarm, command alarm) occurs repeatedly at the
same camera.
2 s/ 3 s/ 5 s/ 10 s
Default:
2 s
[Panasonic alarm port number]
Specify the number of the port to be used for receiv-
ing site alarm.
Default:
1818
Note:
• Enter the port number in five digits, right aligned.
(Example: When the port number is 80, enter
"00080".) The leading zeros are omitted here.
• The following numbers, the HTTP port number, the
HTTPS port number, the FTP port number and the
port number of the port forwarding are unavailable.
20, 21, 23, 25, 42, 53, 67, 68, 69, 79, 80, 105, 110,
123, 161, 162, 443, 546, 547, 995, 10001, 10002,
10003, 10004, 10005, 10006, 10007
[Recording time of emergency recording]
Select a recording duration for the emergency recording.
30 s/ 1 min/ 3 min/ 5 min/ 10 min/ 15 min/ 30 min
Manual: Records only while the connected exter-
nal switch is being pressed. It records at least
8 seconds.
Ext.: Alarm output will continue until the alarm
action is reset.
Default:
30 s
[SD backup rec.]
Set whether to save the image on the SD memory
card or not when the communication is disconnected
during the recording.
On: Uses the SD memory backup function.
Off: Does not use the SD memory backup function.
Default:
Off
SD backup rec.
The SD memory backup is a function to save images
on the SD memory card inserted in the camera when
the recorder fails to communicate with the camera
during the set recording time.
The SD memory backup is only available if the cam-
era supports the SD memory recording and the com-
pression is set to H.264/H.265.
The SD memory recording is done by the registered
compression of the camera.
Note:
• If the camera is set to "Not use" the SD memory
card or the SD memory card is not inserted
(including insufficient insertion), error messages
are displayed some times in a day and recording
is paused for about 20 seconds.
• If the SD backup rec. function is used, set the
operation mode of the SD memory card to
"Overwrite On" from the camera side.
[Setup via recorder's main monitor]
