Panasonic WH-MXF09D3E8, Service Manual

Page: 42 / 125

42
B. If Remote Control Cable Is Exposed
1 Install the remote control lower case to the
wall with the two accessory screws (4).
2 Fasten the screws properly until screw head is
lower than the rib and reach the base of
remote control lower case to ensure they do
not damage the PCB inside the remote control
(1).
3 The feeding-out direction for the remote
control cable can be either via top, left or right
side.
4 Use nipper to cut a notch at the upper case.
(Select the intended feeding-out position)
5 Route the remote control cable (2) inside the
lower case in accordance with the intended
feeding-out direction. (Refer to the illustration
at below)
6 Insert firmly the connector of remote control
cable (2) to connector (CON1) in the upper
case circuit board. (Refer to the illustration at
below)
7 Secure the remote control upper case to the
lower case with the tabs provided.
11.4.3.3 Connecting The Remote Control Cable To Mono bloc Unit
WARNING
Be sure to turn off the main power before installing and
connecting the remote control. Otherwise, it will cause the
electrical shock.
1 Remove the cabinet front plate.
2 Connect the remote control cable with the
provided connector as shown in below
illustration. (Refer wiring diagram for detail.)
3 Guide the remote control cable through the
clamper and Bushing .
(Refer illustration “How to connect Remote
Control to Provided Connector” for detail.)
4 Reinstall the cabinet front plate after
connection complete.