Panasonic VL-V901, Installation And Operating Instructions Manual

Page: 58 / 96

Parameter Description and available settings Default
Building No. Determines the building number for the
corresponding room number.
0
Open Code Determines the open code for each room number. If
disabled, the door cannot be opened using a code.
(4 digits, or #### to disable)
####
(DISABLE)
*5 For systems that support enhanced features version 3 or later (page 92)
When a lobby station is unlocked, a notification sound can be sent from the lobby station depending on the
settings.
Lobby Station 1–3 — General settings
Parameter Description and available settings Default
Door Key Open Time Determines the amount of time the door stays open.
If set to 0 SEC, the door cannot be opened.
(1–20 SEC, or 0 to disable)
5 SEC
Door Key Open Sound Sends a notification sound to the lobby station when
unlocking a door. (A notification sound is also sent
when access controller (door opener, key switch,
card reader, etc.) unlocks a door.)
[0]: NO
[1]: YES
0
(NO)
5.3 Lobby station programming
You can use a lobby station to configure various system settings.
1
Register the lobby station (page 27).
R If you have already registered the lobby station, skip this step.
2
Press M # N
®
enter the access code
®
M N .
For systems that support enhanced features version 2 or later (page 92)
a.
Enter the building number
®
M N .
b. Press M # N
®
enter the access code
®
M N .
R The default access code is "123456". If necessary, you can change the access code (Changing the access
code (Page 58)).
3
Set each parameter.
R You can browse parameters by pressing M N and M N , and select a parameter by pressing M N .
R To cancel, press M N .
R See 5.3.1 List of lobby station programming parameters (Page 59) for information about each parameter.
4
Press M N when finished.
R The lobby station exits programming mode and the standby screen is displayed.
Entering numbers and characters
You can use the keypad to enter numbers and characters.
R Press a key repeatedly to scroll through the characters assigned to that key.
R Follow the hints displayed on the bottom of the display.
– To erase all numbers or characters, press
MHN .
– To advance the cursor, press M # N .
– To cancel, press M N .
– To confirm or save the entered numbers or characters, press M N .
Changing the access code
The access code is required to use the lobby station programming.
58
5. Programming