Panasonic TX-49FX780E, Ehelp

Page: 135 / 340

Note
●
Dual tuner function (watching or recording 2 programmes simultaneously,
watching a programme while recording another programme, etc.) is not
available while using DVB-via-IP server function.
(Only for dual tuner model)
●
TV Guide may also be used to set timer event.
Watching > TV Guide > Timer Programming
●
Timer Programming can store up to 15 events.
●
Timer Programming only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
For recording using Timer Programming , the TV must be either on or in
Standby.
●
Depending on the progress of recording, analogue channel may not be
selected.
(Only for dual tuner model)
●
No other channels can be selected while recording of Timer Programming
is in progress.
(Only for single tuner model)
●
Recording an encrypted (copy-protected) programme may not be possible.
●
Depending on the network condition, recording function may not work
properly in DVB-via-IP.
●
When the start time comes, the channel may be switched automatically
and the video and audio signals may be output. 2 minutes before the start
time, a reminder message may appear if you are watching TV.
(Only for dual
tuner model)
●
When the start time comes, the channel will be switched automatically and
the video and audio signals will be output. 2 minutes before the start time,
a reminder message appears if you are watching TV.
(Only for single tuner model)
– To remove the message and start the programming, press OK .
– To cancel the programming, press EXIT .
●
LED turns to orange in Standby mode when Timer Programming is set.
●
“!” identifies that three or more timer events are overlapped. As for
the overlapped recording events, the first event starts and finishes as
programmed. The next event can then start.
(Only for dual tuner model)
●
“!” identifies that two or more timer events are overlapped. As for the
overlapped recording events, the first event starts and finishes as
programmed. The next event can then start.
(Only for single tuner model)
●
The recording of Timer Programming may automatically change the
channel to the programmed channel a few seconds before the start time.
(Only for dual tuner model)
- 135 -