![background image](http://html.mh-extra.com/html/panasonic/toughbook-cf-19kdraxcm/toughbook-cf-19kdraxcm_service-manual_270619038.webp)
9-15
n
Assembly of LCD Hinge
n
Line Processing of Antenna Cable and LCD Cable
Ensure the "C" side
comes to the lower
right corner when
viewing from above.
Screw
Screw
CAUTION
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
S3
S2
The direction which can rotate
Initial condition of LCD Hinge.
Torque of tightening screw(No.
2) :0.8
㫧
0.08N
䊶
m(
㻍
8.0
㫧
0.8kgf
䊶
cm)
LCD Hinge
Cable Hold Plate
If attached reversely,
the direction of cutting
edge faces the Cable
and this may damage
the Cable. Be careful
of the direction.
Avoid running over the
rib and boss to avoid
catching the Cable
when the Hinge is set.
The position of the Antenna cables:
Black/White/Blue/Gray/Brown or Green
(From the left)
䇭
䇭䇭䇭
Fit the Holder to the Hinge Cover after inserting cables
into the Cable Holder as shown in figure.
Install the Lock Springs on the
Hinge as shown in figure.
Install the Lock Plate on the Hinge
as shown in figure.
Step3
Install the Hinge Cover Assy on the
Hinge as shown in figure.
Direction of rotation
Step4
Step5
LCD Rear Side
Rotate the Hinge part to the arrow
direction as shown in figure.
Step1
Step2
Lock Plate Ass'y
0~2mm
Attach to the bottom face of the Lock Plate.
LCD Cable Protector
Lock Plate Ass'y
Lock Plate Ass'y
Hinge Cover Ass'y
Lock Spring
LCD Cable Holder