Panasonic TH-50PX600U, Operating Instructions Manual

Page: 24 / 65

46 47
Advanced
Recommended
A
V
Connections
RF OUT
RF IN
•
Turn Off the TV speakers.
(p. 32 “Speakers”)
Ŷ
To watch digital video image
S-Video signals have priority
Ŷ
To listen to the TV through
speakers
Amplifier
DVD Player or Set Top Box
(HDMI compatible machines only)
or
Ŷ
To record TV
shows
DVD Recorder /
VCR
Recommended AV Connections
These diagrams show our recommendations for how to connect the TV unit to your various equipment.
For other connections, consult the instructions of each equipment, and the specifications (p. 61).
For additional assistance, please visit our website at : www.panasonic.com
www.panasonic.ca
Camcorder
S-Video
Camcorder
VCR/S-Video
VCR
DVD Player
Ŷ
To watch camcorder
images
INPUT3
Ŷ
To watch DVDs
DVD Player
Set Top Box
Caution
•
For Antenna connection via VCR, please refer to the Operating Instructions for your VCR.
•
If you use both IR Blaster and “HDAVI Control” (P. 34) for the same Panasonic DIGA (with VCR type), please set
“Power off link” (under “Other adjust” of “Setup” menu ) to “No” (P. 34), to avoid failure for your recording.
Cable TV
HDMI
cable
HDMI-DVI
conversion
cable
Audio cable
or
Ŷ
Recommended HDMI Connections (p. 36-37)
•
For receiving digital broadcasting of cable TV,
connect Cable TV directly to “ANTENNA Cable
In” terminal.
or
AC Cord
(Connect after all the other
connections.)
Back of the unit
• Digital audio amplifier
• Theater system
IR Blaster
(Supplied)
(VCR Only)
VCR
G-LINK
•
CableCARD™
Insert a card to watch cable channels serving digital
high-definition video.
Consult the cable company for information.
•
IR Blaster (p. 56)
You can operate the VCR from the TV remote
control or reserve recording with TV Guide.
Install the light emitting area of the IR Blaster near
the signal-receiving area for the remote control on
the VCR.
Signal-emitting area
of remote control
Signal-receiving area of
remote control
Top shelf of TV stand
VCR
Mount with
two-sided tape
Signal-emitting
area
Audio cable
RGB PC cable
Ŷ
To watch
cable TV
Ŷ
PC
Computer
CableCARD™
Conversion adapter (if necessary)
F-Type
Antenna
Adapter
Note
•
To make schedule recording using TV Guide with IR
blaster, you have to select in your VCR Line-1 (L-1)
and set your VCR in OFF condition. (Refer to the
Operating Instruction manual of VCR)
Note
•
The picture and audio input signals
connected to a terminal specified in “Prog-
out stop” (p. 32) cannot be output from
“OUTPUT” terminals. However, audio
output can be obtained from the optical
Digital Audio Out terminal.
•
To prevent howling and image oscillation, set
the “Prog-out-stop” setting when connecting
VCR with loop-connection. (p. 32)
•
When a device (STB, DVD, etc.) is
connected to the HDMI or COMPONENT
terminals, only audio signals will be
output. No video signals will be output.
or
or