9
English
Precautions for use
Cautions when installing
Do not set up the Display outdoors.
•
The Display is designed for indoor use.
Environmental temperature to use this unit
•
When using the unit where it is below 1 400 m (4 593
ft) above sea level: 0 °C to 40 °C (32 °F to 104 °F)
•
When using the unit at high altitudes (1 400 m (4 593
ft) and higher and below 2 800 m (9 186 ft) above sea
level): 0 °C to 35 °C (32 °F to 95 °F)
Do not install the unit where it is 2 800 m (9 186 ft)
and higher above sea level.
•
Failure to do so may shorten the life of the internal
parts and result in malfunctions.
Required space for ventilation
When using the pedestal (optional accessory), leave
a space of 10 cm (3
15/16
”) or more at the top, left and
right, and 5 cm (1
31/32
”) or more at the rear, and also
keep the space between the bottom of the display and
the floor surface.
If using some other setting-up method (wall-hanging,
etc), follow the manual of it. (If there is no specific
indication of installation dimension in the installation
manual, leave a space of 10 cm (3
15/16
”) or more at the
top, bottom, left and right, and 5 cm (1
31/32
”) or more at
the rear.)
Minimum distance:
a
a
b
a: 10 cm
(3
15/16
”)
b: 5 cm
(1
31/32
”)
a
About the screws used when using a wall hanging
bracket that conforms to VESA standards
Inch
model
Screw pitch for
installation
Depth of
screw
hole
Screw
(quantity)
42
200 mm × 200 mm
10 mm
M6 (4)
49
400 mm × 400 mm
10 mm
M6 (4)
55
400 mm × 400 mm
10 mm
M6 (4)
When installing, do not use the screw holes
(situated at the bottom of the display’s back) as
shown in the following figures.
It may damage the LCD panel.
42-inch model
49-inch model
55-inch model
Be careful of the movable structure of the power
indicator and remote control sensor.
•
As factory default, the power indicator and remote
control sensor are stored in the main unit. For normal
use, pull out the remote control sensor from the edge
side of the main unit by operating the lever on the
rear panel. Depending on the setup condition such as
when using the multi display, store the remote control
sensor in the main unit. (see page 25)
Do not grab the liquid crystal panel.
•
Do not forcibly press the liquid crystal panel, or push
it with a pointed object. Applying a strong force to
the liquid crystal panel will cause unevenness of the
screen display, resulting in malfunction.
Depending on the temperature or humidity
conditions, uneven brightness may be observed.
This is not a malfunction.
•
This unevenness will disappear while applying current
continuously. If not, consult the distributor.
