104
LSQT1337
Helpful hints
3
Troubleshooting
Problem
Check points
This unit cannot be
turned on.
This unit does not stay
on long enough.
Battery runs down
quickly.
≥
Charge the battery using the AC adaptor. (
l
18)
≥
The battery protection circuit may have operated. Attach
the battery to the AC adaptor for 5 to 10 seconds. If the unit
still cannot be used, the battery is faulty.
≥
Make sure the LCD monitor is opened.
≥
The battery is affected by ambient temperature. In cold
places, the battery using time becomes shorter.
≥
The battery has a limited life. If the operating time is still too
short even after the battery is fully charged, the battery has
worn out and needs to be replaced.
This unit is turned off
automatically.
≥
If you do not use the unit for approximately 5 minutes, the
power is automatically turned off to conserve battery life. To
resume recording, turn the power back on.
The power will not turn off automatically when the power
save function (
l
29) is set to [OFF].
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥
The unit cannot be operated unless you open the LCD
monitor.
≥
Remove the SD card then press the RESET button.
(
l
107) If normal conditions are not restored yet, remove
the battery or AC adaptor, wait about 1 minute and then
reconnect the battery or AC adaptor. Then about 1 minute
later, turn on the power again. (Conducting the above
operation when the access lamp is on may destroy the data
on the HDD or the SD card.)
A clicking sound is heard
when the power is turned
off.
≥
This is the sound of the lens moving and is not a
malfunction.
The screen has changed
suddenly.
(Demo mode is on)
≥
If you set [DEMO MODE] to [ON] without inserting an SD
card in video recording mode or picture recording mode,
the unit is automatically set to the demonstration mode for
introducing its functions. Normally this should be set to
[OFF]. (
l
30)
SDR-H60&41&40P&PC&PL-LSQT1337_mst.book 104 ページ ２００７年１１月１２日 月曜日 午後１時４６分
